Innovative Products decorative concrete supplies, stamped overlay, spray deck. 

                                            For An Innovative Industry c

 

Home

Products

Show Room

Training

Technical

Request Catalog

Renew-Crete® Systems               
2020 Murrell Rd.  
Rockledge, FL 32955 
888-287-8962 Phone
321-636-8882  Phone
888-875-7012 Fax
321-636-7343 Fax 
Hit Counter

Quick Links

Color Charts

Stamp Mix

Spray-Coat

Re-Coat

Patch-It

Color Hardener

Powder Release

Acid Stain

Stamping Tools

Liquid Release

Concrete Sealers

Plastiform®

Constr. Sprayers

Crack Repair

Co-Polymers

Stamped Concrete

Stamped Overlays

Training Schedule

Renew-Crete®
Liquid Release Agent

Bubblegum Liquid Release Agent
THE ORIGINAL BUBBLE GUM RELEASE FORMULA
hr01.gif (2152 bytes)
Basic Information: Liquid Release Agent
1-Pail = 33-lbs [15-kgs]  Coverage approx. 1000 sq. ft.
 

         Renew-Crete® Liquid Release is a parting agent used to keep texturing mats from sticking to the still plastic concrete.  It also prolongs the life of the texturing mats by decreasing the friction between the texturing mat and the concrete.  It forms a lubricating and parting barrier separating the texturing the concrete from the texturing mats.
        Using a pump type sprayer,  like our   SP-35WC  liberally spray a mist of  Renew-Crete® Liquid Release on colored concrete where you are going to place the next few texturing mats.  Do not apply over an area of more then ten or fifteen square feet as the Liquid Release may evaporate before the mats are placed over it.
         To maintain the integrity of the concrete surface, do not trowel or in any way mix the Liquid Release with the surface.  To make corrections on the still plastic concrete use the texturing mat and press out the unwanted impression.  No removal of Liquid Release is necessary.  When the texturing application is completed, wash off the Liquid Release from the texturing mats using soap and plain water. 
           Renew-Crete®  Liquid Release is formulated to be used with most texturing mats.  However, test a little on texturing mats to insure compatibility before using.      Renew-Crete® Liquid Release is the Original  ''BUBBLE GUM'' release agent, Accept no Imitations!

Great For:

Stamped Concrete

Thin Stamped Overlays

 

hr01.gif (2152 bytes)
Specs:

Product Name: Liquid Release (LR)

Product Class: Hydrocarbon Release Solution

Features:

  • 100% evaporating
  • No clean up required!
  • Pleasant bubblegum scent
  • Eliminates the need for messy powder release agents.

Properties:

  • Appearance: Clear, colorless, solution
  • Smell: Bubble gum
  • Flash Point: 105° F minimum
  • Boiling Range: 313 degrees to 495 degrees F
  • Evaporation Rate: Slower than Ether
  • Weight per gal.: 6.52 Lb.
  • Vapor Density: Heavier than Air
  • % Volatile by Volume: 97.7
  • Application temperature: 40° - 100° F

Available Packaging:

  • Stock 5 gallon pails
  • Stock 55 gallon drums
  • Special Order - Inquire

Suggested Storage:

  • Store in a cool place
  • Shelf Life - 1 year

 

 

 

 
Copyright © 1999, 2000, 2001, 2002, 2003, 2004 Renew-Crete Systems, Inc.. All rights reserved.
Last revised: January 16, 2002